Turbochef-technologies Tornado Manuel d'utilisateur télécharger pdf (Page 16)

ASSEMBLY AND INSTALLATION

5. Remove the legs of the oven that will be placed

on top. This requires two or more persons—at

least one person to lift and one person to

unscrew the legs.

6. Remove the screws from the oven that will be

placed on top, as marked with black arrows in

Figure 4.

7. Place the oven on top of the oven that has the

stacking bracket attached.

WARNING: Do not attempt to lift the oven

with fewer than 2 people.

WARNING: When lifting the oven, position

at least one person on each side. Do not lift

the oven from the front and back, and do not

use the handle to lift the oven.

8. Align the holes on the Stacking Bracket with the

holes on the top oven and reinstall the screws.

WARNING: Do not stack ovens over two-

high.

Built-In Installation (Figure 5)

TurboChef ovens are designed to be installed on a

countertop or table. They are not intended for

built-in or enclosed installation.

“Built-in or enclosed installation” is defined as

installing an oven in any structure that surrounds

the oven by five sides (i.e., top/rear/side panels and

base).

If installation must be “built in,” the operator

must ensure the following:



Minimum of 300 cfm (8.5 cmm) of supplement

flow within the cabinet.



Minimum clearances of 2" (51 mm) to every

surface.

In addition, the operator will be responsible for

compensating any extra time required to service

the product due to removing the product for

serviceability.

Installation Near Open Heat Source (Figure 6)

When placing a TurboChef oven near an open

heat source, strictly adhere to the following:



Verify oven location has a minimum 6" (152

mm) clearance on top and minimum 2" (51

mm) of clearance on each side.



If the oven is being placed near a grill or stove,

there must be a divider between the oven and

the open heat source, with a minimum of 6"

(152 mm) between the oven and the divider.



If the oven is being placed near a fryer, there

must be a divider between the oven and fryer,

with a minimum of 12" (305 mm) between the

oven and the divider.



The height of the divider must be greater than

or equal to the height of the oven (23"/584

mm).

Ventilation Requirements

The TurboChef Tornado

oven has been tested

by Underwriters Laboratory which has concluded

that this oven can be installed and operated ventless

for all food items except for fatty raw proteins, such

as bone-in, skin-on chicken, uncooked hamburger,

fat-laden steaks, etc.

NOTE: In no event shall the manufacturer assume

any liability for damages or injuries resulting from

installations which are not in compliance with the

instructions and codes previously listed.

OVEN ASSEMBLY

Oven Assembly

1. Carefully remove packing materials from the

wire rack.

2. Open the cook cavity door.

3. Remove packing materials from inside the oven.

4. Place wire rack in oven.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Turbochef-technologies Tornado Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Four Turbochef-technologies Tornado